Following the exploration of the previous joints and drawings, we were tasked with our final project of the semester – to create a 16″ x 42″ model of our Martian site as constructed from our previous explorations. This “site” model was to be created based on our previous joints/concepts we had developed, using repetition/mirroring/scaling to take our pattern and extend it for the full 42 inches. Like our previous joints, this model would consist of parts that could be removed and put back together, and would also continue our color scheme. The idea was to take the patterns/spaces we had already developed and extend them to the Martian landscape, exploring how a society might move through and exist within the space (or lack of space) created. Thus, the creation was not a “building” per se, but rather an exploration of form and space as it might pertain to its inhabitants.
Using various sketches I created a design based on the two joints I had constructed out of basswood (and subsequently painted), allowing the two joints to alternate, as well as mirror and rotate, throughout the design. Various pieces of the original joints were merged or skewed to allow for the new model to flow and become one part out of many.
From these sketches, we were tasked to take our model and construct it in Rhino, to allow for proper planning of its construction. Below you can see the model during its conception within Rhino, as well as multiple renderings created of the concept (using plugins within the Rhino interface).
The model was required to incorporate some form of slope into the design – I attempted to accentuate this via a “growth” of the pattern as it traversed the model (scaling). One of the largest difficulties I faced was finding a way for the two different joints (one being very angular and horizontal, the other linear and vertical) to work and flow together. Thus, certain portions of the model were also extended or removed in various directions to attempt to accentuate the conflicting horizontal and vertical as well as angular and linear tendencies of the model. I feel that this also is representative of a society, which may consist of many differing and perhaps conflicting parts or ideas, but yet they still all come together to allow for a functioning whole.
The model was conceived to sit on a “base” or ground, from which the various parts would arise. This ground would become the locking mechanism for the parts. A secondary locking system consisted of various “mask pieces” (a continuation of the mask from previous models) which would sit over portions of the model. These masks became the second concept behind the model – certain parts of a society are readily visible to an outside observer, but other portions are hidden, and certain parts must be removed in order to see these inner workings.